14-72
182582-1CD
182582-1CD
14 Description of Units and Circuit Boards
14.13Universal I/O Signal Assignment
MH900, DX200 Controller
Table 14-9: Specific Output (Spot Welding) (Sheet 1 of 2)
Logical
Number
Output Name / Function
30010 RUNNING
This signal signifies that the job is running. (Signifies that the job is running, system
status is waiting reserved start, or test run is running.) This signal status is the same
status as [START] in the programming pendant.
30011 SERVO IS ON
This signal signifies that the servo power is turned ON, internal processing such as
current position creation is complete, and the system is able to receive the START
command. This signal turns OFF when the servo power supply turns OFF. It can be
used for DX200 status diagnosis for an external start.
30012 TOP OF MASTER JOB
This signal signifies that the execution position is the top of the master job. This signal
can be used to confirm that the master job has been called.
1)
30013 ALARM/ERROR OCCURRED
This signal signifies that an alarm or an error occurred. If a major error occurs, this
signal remains ON until the main power is turned OFF.
30014 BATTERY ALARM
This signal turns ON to notify that the battery requires replacing when the voltage
drops from the battery for backup memory of the encoder. Major problems may result
if memory data is lost because of an expired battery. It is recommended to avoid these
problems by using this signal as a warning signal.
30015 to
30017
REMOTE/PLAY/TEACH MODE SELECTED
This signal notifies the current mode setting. These signals are synchronized with the
mode select switch in the programming pendant. The signal corresponding to the
selected mode turns ON.
30020 IN CUBE 1
This signal turns ON when the current TCP lies inside a pre-defined space (Cube 1).
Use this signal to prevent interference with other manipulators and positioners.
30021 IN CUBE 2
This signal turns ON when the current TCP lies inside a pre-defined space (Cube 2).
Use this signal to prevent interference with other manipulators and positioners.
30022 WORK HOME POSITION (IN CUBE 64)
2)
This signal turns ON when the current TCP lies inside a the work home position area.
Use this signal to evaluate whether the robot is in the start position.
30057 TIP REPLACE REQUEST
This signal is output when the stored number of welding reaches the number of
welding set for the tip replacement.
30023 INTERMEDIATE START OK
This signal turns ON when the manipulator operates. It turns OFF when the currently
executed line is moved with the cursor or when editing operation is carried out after
HOLD is applied during operation. Therefore, this signal can be used as a restart
interlock after a HOLD is applied. However, it also turns ON in the teach mode and
TEACH MODE SELECTED signal must be referred together.
30024 IN CUBE 3
This signal turns ON when the current TCP lies inside a pre-defined space (Cube 3).
Use this signal to prevent interference with other manipulators and positioners.
30025 IN CUBE 4
This signal turns ON when the current TCP lies inside a pre-defined space (Cube 4).
Use this signal to prevent interference with other manipulators and positioners.
30050
3)
WELD ON/OFF
Outputs a signal input from the interlock panel, etc. considering the robot status.
30051
4)
WELD ERROR RESET
This signal commands the reset error status of the Power Source. This is operated
with the programing pendant operation.
To Next Page
Loading...
