Safety
Notes for Safe Operation
vi
182582-1CD
182582-1CD
MH900, DX200 Controller
WARNING
• Maintenance and inspection must be performed by specified
personnel.
Failure to observe this caution may result in electric shock or injury. For
disassembly or repair, contact a Yaskawa representative.
• Read and understand the Explanation of Warning Labels in the
DX200 Instructions before operating the manipulator.
• In some drawings in this manual, protective covers or shields are
removed to show details. Make sure that all the covers or shields
are installed in place before operating this product. The drawings
and photos in this manual are representative examples and
differences may exist between them and the delivered product.
Yaskawa is not responsible for incidents arising from unauthorized
modification of its products. Unauthorized modification voids the
product warranty.
• Perform the following inspection procedures prior to conducting
manipulator teaching. If problems are found, repair them
immediately, and be sure that all other necessary processing has
been performed.
– Check for problems with manipulator movement.
– Check for damage to insulation and sheathing of external wires.
• Always return the programming pendant to the hook on the cabinet
of the DX200 after use.
The programming pendant can be damaged if it is left in the
manipulator's work area, on the floor, or near fixtures.
To Next Page
Loading...
