7 Security System
7.1 Protection Through Security Mode Settings
7-5
182582-1CD
182582-1CD
MH900, DX200 Controller
ARC WELDING ARC START COND. Operation Editing
ARC END COND. Operation Editing
ARC AUX COND. Operation Editing
POWER SOURCE COND. Operation Editing
ARC WELD DIAG. Operation Editing
WEAVING Operation Editing
ARC MONITOR Operation Editing
ARC MONITOR (SAMPL) Operation -
APPLI COND. Management Management
HANDLING HANDLING DIAGNOSIS Operation Editing
SPOT
WELDING
WELD DIAGNOSIS Operation Editing
I/O ALLOCATION Management Management
GUN CONDITION Management Management
SPOT POWER SOURCE
COND.
Management Management
APPLICATION CONDITION
SETTING
Management Management
SPOT
WELDING
(MOTOR GUN)
WELD DIAGNOSIS Operation Editing
GUN PRESSURE Editing Editing
PRESSURE Editing Editing
I/O ALLOCATION Management Management
GUN CONDITION Management Management
CLEARANCE SETTING Operation Editing
SPOT POWER SOURCE
COND.
Management Management
TIP INSTALLATION Operation Management
APPLICATION CONDITION
SETTING
Management Management
GENERAL WEAVING Operation Editing
GENERAL DIAG. Operation Editing
PAINT PAINT SYSTEM CONFIG. Management Management
PAINT SPECIAL Management Management
PAINT CONDITION Operation Editing
CALIBRATION CONFIG. Operation Editing
TIME CHART CONFIG. Management Management
TIME CHART Operation Editing
PAINT DATA CONFIG. Operation Editing
PAINT OUTPUT TEST Management Management
COMMON TO
ALL
APPLICATIONS
I/O VARIABLE CUSTOMIZE Operation Operation
1 Displayed in Teach Mode only.
2 Displayed in the Play Mode only.
3 Displayed when the job reconstruction function is valid.
* When the functional safety is valid, refer to the “DX200 OPTIONS
INSTRUCTIONS FOR FUNCTIONAL SAFETY BOARD OPERATION”
(165988-1CD) for the Menu and Security Mode.
Table 7-2: Menu & Security Mode (Sheet 4 of 4)
Main Menu Sub Menu Allowed Security Mode
DISPLAY EDIT
To Next Page
Loading...
