YOKOGAWA ADMAG TI Series User Manual

<5. Functions>
97
IM 01E21A02-03EN
NE
107
Error Message
Error Description Countermeasure FD bit
Display
F
OUNDATION
Fieldbus
C 101:Param restore run
Parameter restore
running
The restore function
of the parameter was
executed.
- 4 15
N 102:Disp over
Display over
warning
The number of digits
available for display
exceeded the limit.
Check and change the
display parameter.
4 14
N 103:SD size warn
microSD card size
warning
Free space of
the microSD card
decreased to less than
10%.
microSD card may run
out of memory space.
4 13
M 104:Bkup incmplt
Parameter backup
incomplete
Parameter backup
failed.
Retry parameter
backup.
4 12
S 105:SD mismatch
microSD card
mismatch
Mismatch of the
microSD card was
detected.
Change the microSD
card.
4 11
M 106:SD removal ERR
microSD card
removal procedure
error
Removal of the
microSD card failed.
Remove the microSD
card in appropriate
procedures.
4 10
N 131:Trans mismatch
Transmitter type
mismatch
Mismatch of sensor
and transmitter was
detected.
Contact Yokogawa
service center.
3 0
 Information
The device works normally and measurement is also normal. These messages are just reference
information.
NE
107
Error Message
Error Description Countermeasure FD bit
Display
F
OUNDATION
Fieldbus
N 120:Watchdog Watchdog
Error of Watchdog
timer was detected.
Contact Yokogawa
service center.
4 7
N 121:Powero󰀨 Powero󰀨
Power-o󰀨was
detected.
- 4 6
N 122:Inst power FAIL Instant power failure
Instantaneous power
failure was detected.
- 4 5
N 123:Param bkup run
Parameter backup
running
Parameter backup
function is running.
- 4 4
N 124:Data log run
Data logging
running
Data-logging function is
running.
- 4 3
N 133:G/A mismatch G/A mismatch error
As a result of self-
test, inconsistency of
internal circuit was
detected.
Contact Yokogawa
service center.
5 21
N - Write Unlocked
Write lock function
inoperative(Parameter
canbewritten).
Make Write Lock of
resource block Locked.
1 30
N -
Hard Write Lock SW
OFF
Hardware write
protection switch is
turnedo󰀨(writing
enabled).
Turn on the hardware
write protection switch.
1 29
N - Write Locked
Write lock function
operative(Parameter
cannotbewritten).
Make Write Lock
of resource block
Unlocked.
1 28
N -
Hard Write Lock SW
ON
Hardware write
protection switch is
turnedon(writing
disabled).
Turno󰀨thehardware
write protection switch.
1 27
N 248:Simulate SW ON
Simulation Switch
ON
Simulation switch is
turned on.
Turno󰀨thesimulation
switch.
1 23

YOKOGAWA ADMAG TI Series Specifications

General

Brand	YOKOGAWA
Model	ADMAG TI Series
Category	Measuring Instruments
Language	English