3-15
IM MW100-01E
Setting and Data acquisiton
3
Daylight saving Time Setting
1.
From the top screen, click System Setting > Daylight Saving Time Setting.
2.
Select the Daylight Saving Time check box. The Summer time and Winter time
function is enabled.
3.
Select a starting month, week, and day of the week for the start of Summer time
in the Start Time box. Enter a start time in the box.
4.
Select an ending month, week, and day of the week for the end of Summer time
in the End Time box. Enter an end time in the box.
5.
Click the Apply button. The Summer time and Winter time start times are
enabled.
Other Settings
You can set the MW100 unit number, units of temperature, key lock for preventing
inadvertent operations, alarm hold, and rate of change interval.
From the top screen, click System Setting > Other Settings.
Unit Number
1.
Enter a number from 0 to 89 for identifying the unit in the Unit No. box.
2.
Click the Apply button. This enables the setting changes.
Temperature Unit
1.
Select Celsius deg C or Fahrenheit deg F in the Temperature Unit list.
2.
Click the Apply button. This enables the setting changes.
Main Unit Key Lock
1.
If the Key Lock check box is selected, the key lock becomes active.
2.
Click the Apply button. This enables the setting changes.
Alarm Status Hold
1.
If the Hold check box is selected, alarms are held.
2.
Click the Apply button. This enables the setting changes.
For a description of the alarm hold/non-hold, see “Alarms” in section 1.3.
3.3 System Settings
To Next Page
Loading...
Need help?
General
