1-8
IM MW100-01E
1.2 MW100 Operation Guide
The figure below shows the general flow of operation when the MW100 is installed
initially.
Wire the input/
output modules
Operations on the MW100
Connect to the
network
Connect the power
cord
Connect to the
MW100
Configure the
system
Enter data
acquisition
conditions
Set measurement
conditions
MATH settings
FTP and e-mail
settings
Instal the MW100
and attaching the
main module
See the Installation and
Connection Guide
(IM MX100-72E).
Transmission
output settings
Alarm settings
Event settings
Search for all connected MW100s and
configure network parameters such as
the MW100s’ IP addresses.
Select the acquisition interval to be
used, select the recording interval,
set recording start/stop conditions, etc.
Input channel settings, input type,
measurement range, measurement
span, etc.
Analog/PWM output settings
Event/action settings
Settings for the FTP server, mail server,
and other network utilities
Measured data and alarm display
settings while online
Display data using the Viewer software.
See the MW100 Viewer Software User’s
Manual (IM MW180-01E).
While online you can start and stop
data measurement, computation, and
recording from a PC
Starting and stopping data
measurement, computation,
and recording
Alarm level and type settings
Alarm output, manual DO, Fail output,
and error output settings
MW100 system configuration, date
setting, CF card setup
Section 3.3
Section 3.4
Section 3.5
Section 3.6
Section 3.7
Digital output
settings
MATH channel settings, entry of
expressions, etc.
Section 3.8
Section 3.9
Section 3.13
Display and
check data
Monitor data and
alarms
Section 3.15
Section 3.10 and 3.11
Section 3.2
Section 2.5
Section 2.6 to 2.8
Section 2.4
Section 2.2 and 2.3
Start and stop
measurement, computation,
and recording
Section 3.12
Section X.X indicates the referred
sections in this manual.
Operations on the PC
To Next Page
Loading...
Need help?
General
