59
Controls and Indicators
• A Power OFF/Shutdown will reset the printer and then runs the Initial
Power ON sequence.
Note • The Power Failure Recovery Mode is only available on printers with a Printer
Connectivity Module installed in the printer.
2 • Status Indicator — Primary status indicator for overall printer health and
operational status. This indicator is also known as the Power indicator.
• Green: Ready for print and data activity.
• Green, Slowly Changing between ON and OFF: Printer is in Sleep Mode.
• Red: Media out, media detection error, head (cover/printhead) open, cut error,
printhead authentication failure.
• Amber: Printhead Over Temp (temperature), printhead element failure, out of
memory while storing content (formats, graphics, fonts, etc.), and interface
power fault for USB Host or Serial ports.
• Blinking Amber: Printhead Under Temp (temperature)
• Blinking Red: Printhead Over Temp (temperature) — this status is coupled
with blinking red Pause indicator. Requires cooling and printer restart.
3 • Pause Indicator — The printer is in Pause mode when the Pause indicator light is
on. A label (print form) or all labels (print forms) in the print buffer’s queue can be
canceled when the Pause indicator is on using the Cancel button.
• Amber: The printer is paused. Print, label FEED (advance), and other label
routines are suspended until the pause state is removed by pressing the
Pause button.
• Blinking Red: Printhead Over Temp (temperature) — this status is coupled
with blinking red Status indicator. Requires cooling and printer restart.
To Next Page
Loading...