Chapter 43 Backup/Restore
AX/DX/EX/PX Series User’s Guide
494
Restore Configuration
Restore Configuration allows you to upload a new or previously saved configuration file from your
computer to your Zyxel Device.
Do not turn off the Zyxel Device while configuration file upload is in
progress.
After the Zyxel Device configuration has been restored successfully, the login screen appears. Login
again to restart the Zyxel Device.
The Zyxel Device automatically restarts in this time causing a temporary network disconnect. In some
operating systems, you may see the following icon on your desktop.
Figure 278 Network Temporarily Disconnected
If you restore the default configuration, you may need to change the IP address of your computer to be
in the same subnet as that of the default Zyxel Device IP address (192.168.1.1-192.168.225.225).
If the upload was not successful, an error screen will appear. Click OK to go back to the Configuration
screen.
Figure 279 Configuration Upload Error
Reset All Settings
Click the Reset button to clear all user-entered configuration information and return the Zyxel Device to
its factory defaults. The following warning screen appears.
Table 191 Maintenance > Backup/Restore: Restore Configuration
LABEL DESCRIPTION
File Path Enter in the location of the file you want to upload in this field or click Choose File / Browse to find it.
Choose File
/ Browse
Click this to find the file you want to upload. Remember that you must decompress compressed
(.ZIP) files before you can upload them.
Upload Click this to begin the upload process.
Reset Click this to reset your Zyxel Device settings back to the factory default.
To Next Page
Loading...
Need help?
General
