ZyXEL Communications GS2220 Series - Page 431

Chapter 50 Syslog Setup
GS2220 Series User’s Guide
431
Fig ure 330 Management > Syslog Setup
The following table describes the labels in this screen.
Table 226 Management > Syslog Setup
LABEL DESCRIPTIO N
Syslog Select Ac tive to turn on syslog (system logging) and then configure the syslog setting.
Logging Type This column displays the names of the categories of logs that the device can generate.
Active Select this option to set the device to generate logs for the corresponding category.
Facility The log facility allows you to send logs to different files in the syslog server. Refer to the
documentation of your syslog program for more details.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to begin configuring this screen afresh.
Syslog Server Setup
Active Select this check box to have the device send logs to this syslog server. Clear the check box
if you want to create a syslog server entry but not have the device send logs to it (you can
edit the entry later).
Server Address Enter the IPv4 or IPv6 address of the syslog server.
UDP Port The default syslog server port is 514. If your syslog server uses a different port, configure the
one it uses here.
Log Level Select the severity levels of the logs that you want the device to send to this syslog server.
The lower the number, the more critical the logs are.