ZyXEL Communications GS2220 Series - Page 432

Chapter 50 Syslog Setup
GS2220 Series User’s Guide
432
Add Click Add to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to begin configuring this screen afresh.
Clear Click Cle a r to return the fields to the factory defaults.
Index This is the index number of a syslog server entry. Click this number to edit the entry.
Active This field displays Ye s if the device is to send logs to the syslog server. No displays if the
device is not to send logs to the syslog server.
IP Address This field displays the IP address of the syslog server.
UDP Port This field displays the port of the syslog server.
Log Level This field displays the severity level of the logs that the device is to send to this syslog server.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Click De le te to remove the selected entries.
Cancel Click Ca nc e l to begin configuring this screen afresh.
Table 226 Management > Syslog Setup (continued)
LABEL DESCRIPTIO N