ZyXEL Communications GS2220 Series - Page 495

Chapter 61 Switching
GS2220 Series User’s Guide
495
Fig ure 373 Switching > Multicast > IGMP Filtering Profile
The following table describes the labels in this screen.
Click the Add Pro file button to open the following screen. Use this screen to configure an IGMP filtering
profile for the Switch.
Fig ure 374 Switching > Multicast > IGMP Filtering Profile > Add Profile
The following table describes the related labels in this screen.
Table 261 Switching > Multicast > IGMP Filtering Profile
LABEL DESC RIPTIO N
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Profile Name This field displays the descriptive name of the profile.
Start Address This field displays the start of the multicast address range.
End Address This field displays the end of the multicast address range.
Add Profile Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Sa ve link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Add Rule Click this to create a new rule for a profile.
Delete To delete the profiles and all the accompanying rules, select the profiles that you want to
remove in the corresponding row, then click the De le te button.
To delete a rule from a profile, select the rule that you want to remove in the corresponding
row, then click the De le te button.
Table 262 Switching > Multicast > IGMP Filtering Profile > Add Profile
LABEL DESC RIPTIO N
Profile Name Enter a descriptive name for the profile for identification purposes.
To configure additional rules for a profile that you have already added, select the profile
name and specify a different IP multicast address range.
Start Address Type the starting multicast IP address for a range of multicast IP addresses that you want to
belong to the IGMP filter profile.