ZyXEL Communications GS2220 Series - Page 496

Chapter 61 Switching
GS2220 Series User’s Guide
496
Click the Add Rule button to open the following screen. Use this screen to configure a rule for an IGMP
filtering profile.
Fig ure 375 Switching > Multicast > IGMP Filtering Profile > Add Rule
The following table describes the related labels in this screen.
End Address Type the ending multicast IP address for a range of IP addresses that you want to belong to
the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both the Sta rt Addre ss and End
Add re ss fields.
Add Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Sa ve link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Clear Click C le a r to have the fields display blanks.
Cancel Click Ca nc e l to leave this screen.
Table 263 Switching > Multicast > IGMP Filtering Profile > Add Rule
LABEL DESC RIPTIO N
Profile Name Select the profile name to add a rule.
To configure additional rules for a profile that you have already added, select the profile
name and specify a different IP multicast address range.
Start Address Type the starting multicast IP address for a range of multicast IP addresses that you want to
belong to the IGMP filter profile.
End Address Type the ending multicast IP address for a range of IP addresses that you want to belong to
the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both the Sta rt Addre ss and End
Add re ss fields.
Add Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Sa ve link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Clear Click C le a r to have the fields display blanks.
Cancel Click Ca nc e l to leave this screen.
Table 262 Switching > Multicast > IGMP Filtering Profile > Add Profile (continued)
LABEL DESC RIPTIO N