Quality of Service (QoS) Classification Method
NOTE: By L3 Priority classification is limited to a single port only, if "PPP"
encapsulation is selected on bridge.
HH, MH, L or LLL - provide forced priority. ALL of the port's incoming frames are
mapped to the selected queue: HH - Highest, MH - High, L - Medium or LLL -
Lowest.
4. Limiting Rates – note that frames are further handled when egressing (prior to being
forwarded to the HSL wire), at a maximum throughput of 1000 Mbps. If the GBE
option(s) enabled, is will be required to limit the throughput. This can be done by limiting
either the Ingress or the Egress rate:
Limiting Egress Rate – recommended option. See Rate Limit for Egress Rate
configuration criteria for Eth-x and HSL ports.
Limiting Ingress Rate – (available only on Eth-x ports). It is not recommended to
used this option: since the ingress rate limit is applied prior to classification, this type
of limiting conflicts with Quality of Service objectives configured on the NE. See
Rate Limiting (on page 7-5) for more information.
Click OK.
To Next Page