Actelis Networks ML700 - Mitop Applications Parameters

Appendix I - Recommended Actelis MiTOP Configuration Parameters MiTOP Applications Parameters
I-6 User Manual ML700
MiTOP Applications Parameters
Table 117: MiTOP Applications Configuration
Parameter
Default Value
Menu Path
Set
Notes
Applications
Peer Unit
Peer Number
1
Configuration >
Applications > Multiservice
over PSN > Peer
X
Should be kept 1.
Peer Name
Peer Name 1
Optional
Set the Peer site name
(description).
Peer IP
Address
0.0.0.0
Must
Set Peer IP Address.
In case of redundant system:
 Two MiTOP units share the
same interface via Y-cable –
both units should have the
same MGMT IP.
 Two MiTOP units connected to
parallel cables – different
MGMT IP should be provided
for each unit.
Next Hop
address
0.0.0.0
Must
Set Next Hop IP Address.
Peer MAC
Address
000000000000
Optional
Peer MAC IP Address, usually
discovered automatically by
ARP running on SFP.
PW Connection
PW Number
1
Configuration >
Applications > Multiservice
over PSN > PW
X
Only valid value is 1.
PW Name
PW Name 1
Optional
Defining a Pseudowire
Connection.
Discarded by
15
Optional
Set the reasons for counting
discarded frames.
PW Type
SAToP
X
Only valid value is SAToP.
Source IP
0.0.0.0
Configuration >
Applications > Multiservice
over PSN > PW > General
Parameters
Must
Set the source IP for PW traffic
(different from MGMT host IP).
PSN Type
UDP/IPv4
Must
Set the PSN Type (UDP/IPv4,
MPLS, MEF).
Owner
Manually
X
Only valid value is Manually.
OAM
Enable
Optional
Defines OAM functionality.
Unreachable
Detection
Disable
Optional
Defines Mitop operation in
case of unreachable
destination.
Multiplexing
Source
Optional
Define UDP source and
destination ports.