Actelis Networks ML700 - Mitop System Parameters

Appendix I - Recommended Actelis MiTOP Configuration Parameters MiTOP System Parameters
I-2 User Manual ML700
MiTOP System Parameters
Table 115: MiTOP System Configuration
Parameter
Default Value
Menu Path
Set
Notes
System
Management
IP Address
0.0.0.0
Configuration > System >
Management > Host IP
Must
Set the Management IP
address of the device
(Management IP, not for
Service IP).
In case of redundant system:
 Two MiTOP units share the
same interface via Y power
splitter – both units should
have the same MGMT IP.
 Two MiTOP units connected to
parallel cables – a different
MGMT IP should be provided
for each unit.
IP Mask
255.255.255.0
Must
Set the IP Mask (for
Management, not Service).
Default
Gateway
0.0.0.0
Must
Set the Default Gateway IP
address (for Management, not
Service). In order to be in the
same MGMT plane where ML
NE are managed, use default
values proposed by
MetaASSIST View.
Host Tagging
Untagged
Optional
This parameter is
automatically set to TAGGED
by the MAV when MGMT
interface is configured on SFP.
Untagged option is reserved
for TRAFFIC VID.
Host VLAN ID
-
Optional
Enter Host VLAN ID. The
parameter is automatically set
with MGMT VID as on ML by
the MAV, when MGMT
interface is configured on SFP.
Note: ETH-x must be
configured as MGMT VLAN
member on ML.
Host VLAN
Priority
-
Optional
Enter Host VLAN Priority.
Parameter is automatically set
as COS=7 by the MAV when
MGMT interface is configured
on SFP.