Actelis Networks ML700 - MiTOP System Parameters

Appendix I - Recommended Actelis MiTOP Configuration Parameters
ML700 User Manual I-3
Parameter
Default Value
Menu Path
Set
Notes
Device Name
MiTOP-T3
Configuration > System
>Management > Device
Info
Optional
Enter device name.
Device Location
-
Optional
Enter device location (text).
Contact Person
-
Optional
Enter the name of a contact
person (text).
User account:
User Level,
User Name,
Password
Su, 1234
Configuration > System >
Management > User
Access
Optional
Define Management Access
Permissions for users.
LAN (Web)
Enable
Configuration > System >
Management >
Management Access
Optional
Management to the device is
lost if changed to Disable. To
restore the management,
either use the Restrat button
(reset to factory, all settings
are lost) or connect the device
to external SFP-CA,
configuration module and
change back to LAN.
Outband Mode
Normal
Configuration > System >
Management > Outband
X
Keep default settings.
Fault Propagation
LOS
Disable
Configuration > System >
Fault Propagation
Optional
Set LOS propagation (TDM to
Eth.) behavior.
Note: Configuring LOS
propagation to Enable will
prevent management
connectivity to the MiTOP in
case of TDM interface LOS.
For redundant system, if port
equipped with SFP is listed as
APS trigger, LOS propagation
must be enabled.
AIS
Disable
Optional
Set LOS propagation (TDM to
Eth.) behavior.
Note: Configuring AIS
propagation to Enable will
prevent management
connectivity to the MiTOP in
case of TDM interface AIS.
For redundant system see LOS
propagation above.
Fault
Propagation
WTR
0
Optional
Enables setting the Wait to
Restore time (if propagation
enabled).
TX Disable