Actelis Networks ML700 - Commissioning Procedure

Getting Started Commissioning Procedure
2-2 User Manual ML700
Commissioning Procedure
To install the ML unit and equipment properly, use the Installation Guide (provided on ML
CD) to assist in the installation.
 To start the configuration procedure
 The management host/PC and ML unit must be connected via the CRAFT port. Since the
IP addresses of ML devices are initially set (factory default) to 0.0.0.0, the COLAN port
cannot be used for telnet connection.
 The CRAFT port setting on the management host/computer should match the ML device.
Initially (after factory setup) all ML devices accept 9600 bps baud rate.
 See Appendix C with Step-by-Step Commissioning procedure (on page C-1)