ML products perform an extensive Self-test during power up, checking the
installed hardware, data paths and system configuration. In addition, an in-
service diagnostic test is periodically performed during normal operation,
ensuring system sanity. In case of an alarmed condition, an indication of the
event is given through:
- Front panel LEDs
- Office alarms transmitted via the alarm relays
- Autonomous TL1 reports, alarms and non-alarmed conditions
- SNMP traps
For more information or if you are unable to resolve a problem using these
procedures, contact Actelis Networks customer support at
techsupport@actelis.com.
In This Chapter
Recommended Test Equipment ................................. 15-2
LED Fault Indications ................................................. 15-3
Dry Contact Alarm Indications .................................... 15-5
Alarmed Conditions .................................................... 15-6
Copper Line Troubleshooting ..................................... 15-9
Ethernet Service Troubleshooting ............................ 15-16
Management Connection Problems ......................... 15-25
Resolving Management Connection Problems ......... 15-29
To Next Page