Monitoring Error Counters, Measurements and Threshold Alerts
The filtering options allow you to minimize the amount of data to configure:
Type - lists the counter types. Select a specific counter type or ALL to set the
threshold for all counters.
Location - select a specific (NEND, FEND, Line-x, etc.), or ALL to set the threshold
for counters from all locations.
Time Period - select Period over which the threshold will be applied (recommended
selection is 1 Day).
3. In the Apply level to all, enter the threshold level value (in seconds). This causes an alert
report when the number of counted error seconds exceeds crosses configured threshold
level. (Note that '0' level, prevents TCA generation.
4. Click OK.
To Next Page