!"
9;=
*Can’t create new slide bar* (–557)
Explanation: An attempt has been made to create a graphic slide bar in the hori-
zontal or vertical scroll bar. Slide bars should be created only in the
main window, although they can appear in the title or menu bars.
User action: Modify the arguments for the GSLIDE instruction to have the slide
bar created within the window.
*Can’t create program in read-only mode* (–364)
Explanation: An attempt has been made to initiate editing of a program in
read-only access mode, but the program does not exist.
User action: If the program name was entered incorrectly, enter the command
again with the correct name. Do not select read-only access (with
/R) when creating a new program.
*Can’t delete .PROGRAM statement* (–350)
Explanation: An attempt has been made to delete the .PROGRAM statement
while editing a program.
User action: To change the .PROGRAM statement, replace it with another .PRO-
GRAM statement. To delete lines at the beginning of the program,
move down to line 2 before issuing delete commands.
*Can’t execute from SEE program instruction* (–362)
Explanation: An attempt has been made to use a SEE editor command that cannot
be used after the editor has been initiated with the SEE program
instruction.
User action: Enter another command or exit the editor and reenter from the V
+
monitor.
*Can’t exit while lines attached* (–355)
Explanation: You attempted to terminate execution of the editor while lines were
present in the attach buffer. The attach buffer must be empty before
the editor can be exited.
User action: You can use SHIFT+Copy to deposit the contents of the attach buffer
into the current program. You can also use ESC+K to delete lines
from the attach buffer (99 ESC+K deletes up to 99 lines from the
buffer).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
