!"
99
*No air pressure* (–607)
Explanation: V
+
detected that the air supply to the robot brakes and hand has
failed. High power is turned off and cannot be turned on until the
air pressure is restored.
User action: Restore the air pressure, turn high power back on, and resume pro-
gram execution. If the error persists, contact Adept Customer Ser-
vice.
*No data received* (–526)
Explanation: An I/O read request without wait has not found any data to return.
This is not really an error condition.
User action: Continue polling the I/O device until data is received, or use a read
request that waits automatically for data to be received.
*No matching connection* (–539)
Explanation: A request for a logical network connection has been received and
rejected because there is no matching connection on the remote
node.
User action: Check that the proper logical connection was specified. Check that
the remote node is operating properly.
*No models* (–758)
Explanation: The VSTORE program instruction or monitor command has not
found any models to store.
User action: Supply correct model names to the VSTORE instruction.
*No models planned* (–761)
Explanation: Recognition cannot commence because no object models have been
planned for the given virtual camera.
User action: Supply the correct virtual camera number or plan that uses the spec-
ified camera number. (See the VPLAN.FINDER instruction in the
AdeptVision Reference Guide.)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General