EasyManuals Logo

adept technology MV User Manual

adept technology MV
404 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #340 background imageLoading...
Page #340 background image
  !"
  <
*RSC reset* (–652)
Explanation: V
+
has detected that the robot signature card (RSC) has lost power
temporarily, but is now functioning.
User action: Turn high power back on and resume program execution. If the
problem persists, check the cabling to the robot. Contact Adept Cus-
tomer Service if no solution can be found.
*RSC time-out* (–653)
Explanation: V
+
has not received a response from the robot signature card (RSC)
when expected, during the initial calibration data load. The RSC or
its cabling is probably faulty.
User action: Power down the controller and check the cables to the robot. If the
problem persists, contact Adept Customer Service.
*RSC transmission garbled* (–654)
Explanation: V
+
has received an invalid transmission from the robot signature
card (RSC). Either a hardware problem has occurred or the robot is
being operated in an environment with excessive electrical noise.
User action: None unless the calibration load fails or RSC communications fail. If
the problem persists, contact Adept Customer Service.
Searching for string (exact case) (None)
Explanation: The SEE editor command 0’ has been entered. The editor is prepared
to search for the string indicated, in the search mode indicated.
User action: This is an informational message. You can use the Repeat command
to perform the indicated search, or you can use Find (or Change) to
initiate a new search (or replacement) operation. The EXACT
extended command controls the setting of the search mode.
Searching for string (ignoring case) (None)
Explanation: The SEE editor command 0’ has been entered. The editor is prepared
to search for the string indicated, in the search mode indicated.
User action: This is an informational message. You can use the Repeat command
to perform the indicated search; or you can use Find (or Change) to
initiate a new search (or replacement) operation. The EXACT
extended command controls the setting of the search mode.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Table of Contents

Other manuals for adept technology MV

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the adept technology MV and is the answer not in the manual?

adept technology MV Specifications

General IconGeneral
Brandadept technology
ModelMV
CategoryController
LanguageEnglish