Anritsu MT8852B - Appendix B Test Conditions

MT8852B Operation Manual PN: 13000-00205 Rev. N B-1
Appendix B — Test Conditions
B-1 Test Condition
As detailed in chapter 5, each test that can be run on the MT8852B has a number of test
conditions that determine exactly how the test is performed. The test conditions are set by
default to match the requirements defined in the Bluetooth specification. The test conditions
for scripts 1 and 2 cannot be modified but those for scripts 3 to 10 can be changed by the user
to meet requirements.
The table below shows the test conditions that are used in each test.
Table B-1. Test Con d iti ons Pe r Tes t
Hopping Hopping test mode No. of packets Test type Packet type Cycles Packets per step Min. test power Measurement delay Tx power Payload pkt count Dirty transmitter Dirty params table Toggle payload DHx packet type EUT power level Min sensitivity check Edit dirty table Threshold bit count Total test bit count Number of bits Number of blocks Frequency
Output
power
Power
control
Enh. pwr
control
Initial
carrier
Carrier
drift
Single
sens.
Multi
sens.
Mod.
index
Max
input pwr
Rel. Tx
power
Carrier &
mod.