Anritsu MT8852B - Glossary; B-2 Glossary

Glossary
B-2 PN: 13000-00205 Rev. N MT8852B Operation Manual
B-2 Glossary
Cycles
In the power control measurements, this sets the number of power measurement cycles. A
power measurement cycle sets the EUT output power to its maximum, steps it down to the
minimum, and then up to the maximum again.
In the PER integrity measurement, this represents the number of times that the test is run
with a new random number each time.
DHx packet type
The DHx packet type used in all EDR tests. There are five settings (Longest, 2-DH1, 2-DH3,
2-DH5, Off) available for both the 2 and 3 Mbs settings.
Diff.
phase
EDR
sens.
EDR
BER floor
EDR max
inp. level
Output
power
Carrier
drift
Mod.
index
Sensi-
tivity
PER
integrity
Max
input pwr
Table B-1. Test Conditions Per Test
Hopping Hopping test mode No. of packets Test type Packet type Cycles Packets per step Min. test power Measurement delay Tx power Payload pkt count Dirty transmitter Dirty params table Toggle payload DHx packet type EUT power level Min sensitivity check Edit dirty table Threshold bit count Total test bit count Number of bits Number of blocks Frequency