Configurations for Testing Instrument Overview
4-10 PN: 13000-00205 Rev. N MT8852B Operation Manual
Over-air Connection
1. Connect the Bluetooth antenna to the RF port on the front of the MT8852B.
2. If using the MT8852B to initialise the EUT, connect the RS232 HCI control interface
lead (supplied), or USB HCI control interface lead (supplied) from the control connector
on the front of the MT8852B to the HCI interface on the EUT.
If not using the MT8852B to initialise the EUT, it must be initialized locally to accept a
connection and enter Test Mode.
3. Ensure the MT8852B is connected to the mains power supply.
4. Press the [On/Standby] key on the front panel of the MT8852B.
5. The MT8852B performs a brief power-on self test (POST). After the POST, the
instrument displays the Test group menu. If a POST error occurs, information and
available options will be displayed on the screen.
6. Press to restore the default settings. See Appendix C, Preset Values for
details.
Figure 4-10. Over-Air Connections
To Next Page
Loading...
