Error Messages
MT8852B Operation Manual PN: 13000-00205 Rev. N D-7
Single Payload mode MT8852B has been configured to test an EUT by sending
one test control at a time. This limits the speed with which a
range of measurements can be made, but can improve
reliability with EUTs that do not yet have a robust
implementation of test mode signalling. To return to the
standard Bluetooth operating mode press Scpt/Test, move
the pointer to the script number and press the setup soft key.
Set “Script mode” to Standard.
Synchronization error The EUT control RS232 control of the EUT has received an
illegal sequence.
System auto-ranging The measurement system unexpectedly required an range
change.
Test stopping A test stop has been requested and the test is in the process
of stopping.
USB device attached A USB device has been attached and is ready.
USB device removed A USB device has been removed.
Unknown HCI command When under External HCI control, an unrecognized HCI
command has been received.
Unsupported feature The EUT has been requested to use a feature it does not
support.
Table D-1. Error Messages
Message Meaning
To Next Page
Loading...
