Safety-3
For Safety
Warning
• ALWAYS refer to the operation manual when working near
locations at which the alert mark shown on the left is attached. If
the advice in the operation manual is not followed, there is a risk
of personal injury or reduced equipment performance. The alert
mark shown on the left may also be used with other marks and
descriptions to indicate other dangers.
• Overvoltage Category
This equipment complies with overvoltage category II defined in
IEC 61010. DO NOT connect this equipment to the power supply
of overvoltage category III or IV.
Warning
When supplying power to this equipment, connect the accessory 3-
pin power cord to a 3-pin grounded power outlet. If a grounded 3-pin
outlet is not available, use a conversion adapter and ground the
green wire, or connect the frame ground on the rear panel of the
equipment to ground. If power is supplied without grounding the
equipment, there is a risk of receiving a severe or fatal electric shock.
Warning
Only qualified service personnel with a knowledge of electrical fire
and shock hazards should service this equipment. This equipment
cannot be repaired by the operator. DO NOT attempt to remove the
equipment covers or unit covers or to disassemble internal
components. There are high-voltage parts in this equipment
presenting a risk of severe injury or fatal electric shock to untrained
personnel. In addition, there is a risk of damage to precision
components.
Warning
The performance-guarantee seal verifies the integrity of the
equipment. To ensure the continued integrity of the equipment, only
Anritsu service personnel, or service personnel of an Anritsu sales
representative, should break this seal to repair or calibrate the
equipment. Be careful not to break the seal by opening the equipment
or unit covers. If the performance-guarantee seal is broken by you or
a third party, the performance of the equipment cannot be
guaranteed.
Caution
Never input a signal of more than the indicated value between the
measured terminal and ground. Input of an excessive signal may
damage the equipment.
To Next Page
Loading...
