Configuring a Script Test Scripts
5-6 PN: 13000-00205 Rev. N MT8852B Operation Manual
7. Press the [1 of x] soft key to display the second page of test conditions and repeat the
process described above. The number of pages of test conditions differs depending on
the test.
8. Navigate to the last page of test conditions where the EUT Tx and Rx values display for
each of the low, medium, and high frequencies at which the test will be conducted. The
frequencies match the requirements defined in the Bluetooth specification, but can be
changed by the user if so required. If the “Test type” test condition is set to “Tx mode”,
the Tx and Rx frequencies are set to the same value.
Figure 5-6. Tx and Rx Power Settings
To Next Page
Loading...
