Baumuller b maXX BM5800 - Page 264

Configuration
Parameter manual b maXX BM5800
Document No.: 5.16029.03 Baumüller Nürnberg GmbH
264
of 814
3.4
147.21 Torque init stress actual value master
Display of the present torque init stress of the master at torque coupling in the format for
transmission via fieldbus. It is dependent on place and connection of the torque init stress.
1 Torque init stress acts via compensating controller Z147.1– Bit 16 = 0
No Meaning
2 Torque init stress acts directly on the torque set values
m Master
Display of the present torque init stress which is parameterized and generated of the
master.

This parameter must be sent cyclic from the master to the slave.
At external master-slave communication this parameter must be sent via cross com-
munication (fieldbus) or analog inputs/outputs. See also ZCross communication–
on page 256.
An external transmission is not required at internal master-slave communication.
m Slave
Display of the present torque init stress which is parameterized and generated of the
master and sent to the slave.