Baumuller b maXX BM5800 - Page 285

Description of the Software Modules and Parameters
Parameter manual b maXX BM5800
Document No.: 5.16029.03
285
of 814
3
179.7 Gear ratio drive shaft revolutions
DS402 Factor Group object 0x6091.02 (denominator of the gear ratio).
179.8 Feed constant feed
DS402 Factor Group object 0x6092.01 (numerator of the feed constant).
179.9 Feed constant drive shaft revolutions
DS402 Factor Group object 0x6092.02 (denominator of the feed constant).
179.10 Position actual value
DS402 Factor Group object 0x6064 (position actual value with position weighting corre-
sponding to ZGeneral information– from page 277).
179.11 Position window
DS402 Factor Group object 0x6067 (positioning window for the operating mode "Position
target setting" with position weighting corresponding to
ZGeneral information– from page
277).
179.12 Target position
DS402 Factor Group object 0x607A (target position for the operating modes "Position tar-
get setting" (only modes with relative target position) and "Cyclical set value setting" with
position weighting corresponding to
ZGeneral information– from page 277).
179.13 Home offset
DS402 Factor Group object 0x607C (home offset for the operating mode "Homing" with
position weighting corresponding to
ZGeneral information– from page 277).