Description of the Software Modules and Parameters
Parameter manual b maXX BM5800
Document No.: 5.16029.03
605
of 814
3
The parameter must be distinguished from the speed additional set value, which has a
direct effect on the speed control input!
136.8 Output position set value
This parameter shows the calculated target position after offset addition and is updated
during the cycle of the set value interface.
The displayed value is in format 16 Bit revolution + 16 Bit angle.
136.9 Output speed set value
This parameter shows the generated output speed set value after offset addition and after
PT
1
smoothing.
The displayed value is in format 16 bits increments/revolution per ms.
136.10 Output Acceleration Set Value
This parameter shows the generated output set value speed after offset addition and is
updated during the cycle of the set value interface.
The displayed value is in format 16 bits increments/revolution per ms².
136.11 Effective Interpolation Interval
Parameter to display the effective interpolation interval:
Interpolation interval = Factor * Fieldbus cycle time
The factor can be adjusted in Parameter Z136.2– Mode in bits 12 and 13.
The fieldbus cycle time is adjusted in Parameter Z131.18–.
136.12 Output Angle Set Value
This parameter shows the calculated set value angle after offset addition and is updated
during the cycle of the set value interface.
The displayed value is in format 32 Bit angle.
To Next Page
Loading...