Baumuller b maXX BM5800 - Page 616

Operating Modes
Parameter manual b maXX BM5800
Document No.: 5.16029.03 Baumüller Nürnberg GmbH
616
of 814
3.8
Example of a changeover of a transmission ratio from 0.8 to 1.15:
– Application of the Transparent Mode (Z145.2– Mode bit 4 = 0):
– or change slave axis revolutions first:
– Application of the Edit Mode (Z145.2– Mode bit 4 = 1):
 No undesired transmission ratios occur in Edit Mode!
i Z145.4– Rot. Master axis Z145.3– Rot. Slave axis
0.2 10 2
- 0.78 100 - 78
3.15 100 315
6.54321 100000 654321
0.3333 10000 3333
Rot. Master axis Rot. Slave axis Mode bit 4 Transmission
Ratio i
10 8 0 0,8
10  100 8 0 0.8  0.08
100 8  115 0 0.08  1.15
Rot. Master axis Rot. Slave axis Mode bit 4 Transmission
Ratio i
10 8 0 0,8
10 8  115 0 0.8  11.5
10  100 115 0 11.5  1.15
NOTE!
Undesired transmission ratios may occur in the Transparent Mode!
Rot. Master axis Rot. Slave axis Mode bit 4 Transmission
Ratio i
10 8 0 0.8
10 8 0  1 0.8
10  100 8 1 0.8
100 8  115 1 0.8
100 115 1  0 0.08  1.15