Baumuller b maXX BM5800 - Page 698

Diagnosis
Parameter manual b maXX BM5800
Document No.: 5.16029.03 Baumüller Nürnberg GmbH
698
of 814
3.10
104.7 FFT mode
This parameter is used to set the FFT mode. The mode is used to configure the internal
signal generator.

The parameter 104.7 FFT mode is independent from Parameter Z104.1– Command.
104.8 FFT info
This parameter shows the current information/error of the module.
FFT Mode Meaning
Value 0 Signal generator not active, default setting
Bit 1 set (0x02) Hissing noise signal generator (15 Bit) active
Bit 3 ... 2 Reserved
Bit 4 set (0x10) Sine generator active
Bit 5 set (0x20) PRBS signal generator active
Bit 6 set (0x40) Hissing noise signal generator (31 Bit) active
Bit 32 ... 7 Reserved
Value Meaning
0 No error
1 Internal memory for Vector 1 could not be allocated, e.g. due to configured
ring buffer
2 Internal memory for Vector 2 could not be allocated, e.g. due to configured
ring buffer
3 Internal memory for Vector 3 could not be allocated, e.g. due to configured
ring buffer
4 Error wrong command or FFT was interrupted
5 The input parameter configured in Parameter Z104.3– "Signal input 1
source Pxxx" cannot be read.
6 The input parameter configured in Parameter Z104.4– "Signal input 2
source Pxxx" cannot be read.
10 Error while reading out the determined curve through Parameter Z104.21–
12 The number of measured values Z104.9– was indicated outside of the per-
mitted range.