Biotek MultiFlo FX - Page 314

292 | Appendix A: Error Codes
Code Message What to do
810F The command was received
while the software was not
ready to accept that command
Contact BioTek TAC.
A00 Invalid plate type requested Service Only.
Contact BioTek TAC.
A100 -
A10F
Software device not available Service Only.
Contact BioTek TAC.
A200 Version strings for multiple
microprocessors do not match
Service Only.
Contact BioTek TAC.
A301 +5v logic power supply level
error
Service Only.
Contact BioTek TAC.
A302 +24v system/motor power
supply level error
Service Only.
Contact BioTek TAC.
A303 +42v Peri-pump motor power
supply level error
Service Only.
Contact BioTek TAC.
A305 +42v Secondary Peri-pump
motor power supply level error
Service Only.
Contact BioTek TAC.
A400 Malloc failed Service Only.
Contact BioTek TAC.
A500 Multiple tasks attempted to use
display simultaneously
Service Only.
Contact BioTek TAC.
A600 Serial EEPROM access error Service Only.
Contact BioTek TAC.
A700 Motor truncation error: X axis.
Carrier X-axis motor steps are
being truncated based on the
profile
Service Only.
Contact BioTek TAC.
A701 Motor truncation error: Y axis.
Carrier Y-axis motor steps are
being truncated based on the
profile
Service Only.
Contact BioTek TAC.
A702 Motor truncation error:
Dispense head motor steps are
being truncated based on the
profile
Service Only.
Contact BioTek TAC.
MultiFlo™ FX Multi-Mode Dispenser