Biotek MultiFlo FX - Page 8

vi | MultiFlo FX Operator's Manual
Use the BioStack 125
Re-stack plates in the BioStack 127
Nth Plate to perform special process 127
About the Nth Plate Step 128
Advanced Plate Sequencing with the BioStack 129
Plate Types and Processing Patterns 133
Handling Special Plates and Mini-tubes 134
1536F - 1536-well Flanged Plates 134
Peri-pump Special Plate Handling 134
Special Plate Carrier for Mini-tubes 136
Mini-Tube Racks 137
Dispensing to Mini-Tubes 137
Dispense Processing Patterns 138
8-Channel Dispenser Dispense Pattern 139
Dispense Pattern with Both Syringes 140
Washer Operation 141
About the MultiFlo FX Wash Step 141
Cell Wash 142
Define a Cell Wash Protocol 142
Cell Wash Strategies 143
Biomagnetic Separation - Magnetic Bead Assays 145
Perform Magnetic Bead Assays 146
Optimize Magnetic Bead Protocols 147
Flat Magnets 147
Ring Magnets 148
How to determine the Magnet Adapter Height Offset 149
Magnet Height Offset 150
Special Procedure for Magnetic Bead Assays 151
Peri-pump Peristaltic Dispenser 152
Peri-pump: How it works 153
Release the tension on the dispense cassette 154
Peri-pump Dispense Step 155
RADTip Tracking 156
RAD Well Map 157
Require a Specific Peri-pump Cassette 158
Peri-pump Advanced Settings 159
Settings for 0.5 µL Dispense 159
8-to-1 Tube RAD Cassette 159
Dual Syringe Dispenser 160
How to Prime the Syringe dispenser 160
Syringe Prime Step 161
Syringe Dispense Step 163
Change the Syringe Dispenser Manifold 165
Syringe Dispenser Settings 166
Syringe Dispenser- Autoclavable vs. Non-autoclavable 167
Changing the Instrument's Settings 168
Dispense Pattern 168
MultiFlo™ FX Multi-Mode Dispenser