Notices| v
Update the Instrument to use the Syringe Dispenser 74
Change the Syringe Dispenser Manifold 75
Change the cassette type setting 76
Setting the Time and Date 77
Define Startup Preferences (LHC users only) 77
Verify Performance 79
Verify the Peri-Pump Dispenser 80
Verify the Syringe Dispensers 80
Verify the Washer Component 81
Repacking the MultiFlo FX 82
Install the Shipping Hardware 83
Repacking the Secondary Peri-pump 85
MultiFlo FX Repacking 86
Repacking the Syringe Dispenser 89
Repacking the Strip Washer 90
Operation 91
Touch Screen Basics 92
Quick Prime 93
Quick Dispense 94
Quick Wash 95
Add protocols to the Home screen 95
Remove protocols from the Home screen 95
Get protocols from a memory stick - USB drive 96
Hardware Change Detected 96
Optimize Performance 98
Recommended prime volumes for the Strip Washer 99
Recommended prime volumes for the Peri-pump 99
Recommended prime volumes for the Syringe dispensers 101
Optimize protocols to improve evacuation 101
Add a secondary aspiration to a wash cycle 101
Create or Modify a Protocol 102
Protocol Parameters Tables 103
Wash Parameters Table 108
Washer Flow Rates 111
Pre-Dispense 113
Minimum Prime Volumes for the Strip Washer 114
Bottom Wash 114
Change the Plate Type 115
Rename a protocol 115
Shake/Soak Step Parameters 116
Repeat steps in a Loop 116
Delay the Protocol 117
Timer Activated Delay 118
RUN: Running Predefined Protocols 120
LHC Users Only: Customize the Predefined Protocols 120
Predefined Protocols Listing 121
Predefined Sample Protocols 122
Operating with the BioStack 124
BioTek Instruments, Inc.
To Next Page
Loading...
