Brother HL-S7000DN - Page 103

2-75
Confidential
■ Error code 7001
Paper jam. (Paper feed sensor is at paper feeding state, and after registration front sensor
detected that paper is fed, even if a certain amount of papers is fed, print starting sensor does
not change to paper feeding state.)
<User Check>
- Remove the jammed paper.
■ Error code 7002
Paper jam. (After registration front sensor detected paper feeding while paper feed sensor is
at no paper state, even if a certain amount of paper is fed, print starting sensor does not
change to paper feeding state.)
<User Check>
- Remove the jammed paper.
Jam B Inside
Open the Top Cover and MP tray. Then Release the green levers. Follow step
B to remove jammed paper.
Step Cause Remedy
1 Foreign object inclusion in the
front chute
Remove foreign object in the front chute.
2 Coming off of registration front
actuator
Re-assemble the registration front
actuator.
3 Registration front sensor harness
connection failure
Reconnect the registration front sensor
harness.
4 Paper feed PCB failure Replace the paper feed PCB ASSY.
5 Main PCB failure Replace the main PCB ASSY.
Jam B Inside
Open the Top Cover and MP tray. Then Release the green levers. Follow step
B to remove jammed paper.
Step Cause Remedy
1 Foreign object inclusion in the
front chute
Remove foreign object in the front chute.
2 Coming off of registration front
actuator
Re-assemble the registration front
actuator.
3 Edge sensor harness
connection failure
Reconnect the edge sensor harness.
4 Registration front sensor harness
connection failure
Reconnect the registration front sensor
harness.
5 Paper feed PCB failure Replace the paper feed PCB ASSY.
6 Main PCB failure Replace the main PCB ASSY.