Brother HL-S7000DN - 7. WHEN REPLACING ENGINE PCB ASSY

4-33
Confidential
7. WHEN REPLACING ENGINE PCB ASSY
<What to do when replacing the Engine PCB ASSY>
■ Before replacement
- Nothing in particular
■ After replacement
- 7.1 Installing the Firmware
- 7.2 Adjustment of Waste Ink Box Sensor (Maintenance Mode: Code 19)
- 7.3 Input of Platen Adjustment Value (Maintenance Mode: Code 31)
- 7.4 Adjustment of Print Start Position(Maintenance Mode: Code 68)
- 7.5 Printing of All Check Patterns
<What you need to prepare>
(1) A USB flash memory drive
(2) A USB cable
(3) Create a temporary folder on the C drive on the computer (Windows
®
XP or later).
(4) Service setting tool (brusbsn.zip)
Copy it into the temporary folder created on the C drive. Decompress the copied file and
double click "brusbsn.exe" included in the extracted file.
(5) The download utility (FILEDG32.EXE)
Copy it into the temporary folder created on the C drive.
(6) The Brother maintenance USB printer driver (MaintenanceDriver.zip)
If the maintenance printer driver is not installed, copy it into the folder created on the C
drive, decompress and install it.
(7) The firmware
LZ4172_$.djf (Engine head maintenance firmware)
(8) All patterns data (pattern01.prn)
(9) A waste ink box that is not full of waste ink.