5-5
Confidential
1.4.3 Worker switch (WSW) setting (Function code 10)
<Function>
The machine incorporates the following worker switch functions which may be activated with
the procedures using the buttons on the control panel. The worker switches have been set at
the factory in conformity to the codes of each country. Do not disturb them unless necessary.
<Operating procedure>
(1) Press the 1 and 0 buttons in this order in the initial state of the maintenance mode.
The machine displays "WSW00" on the LCD and becomes ready to accept a worker
switch number.
(2) Enter the number of worker switch to change using the ten-key pad. The following is
displayed on the LCD.
(3) Press the or button to move the underline cursor to the position of the selector to be
changed.
(4) Press the 0 or 1 button to change the selector value.
(5) When you finish entering the value, press the OK button. This operation saves the newly
entered selector values onto the EEPROM and readies the machine for accepting a
firmware switch number. The machine displays "WSW00" on the LCD again to accept a
worker switch number.
(6) After entering values for all switches, press the Cancel button to return the machine to the
initial state of the maintenance mode.
WSW No. Function
WSW17 Switching of the time display method
WSW47 Switching between high-speed USB and full-speed USB
WSW56 Function setting 21
WSW59 Enabling and disabling of transmission of USB serial number
WSW63 Switching of the time display method/Font support for Israel
WSW64 Setting the language/Default paper size
WSW65 Default media type/Range of supported media types
Memo:
- To cancel this operation and return to the machine to the initial state of the maintenance
mode during the above procedure, press the Cancel button.
- If there is a pause of more than one minute after a single-digit number is entered for
double-digit worker switch numbers, the machine will automatically return to the initial
state of the maintenance mode.
Selector 1 Selector 8
To Next Page
Loading...
Need help?
General
Weight and Dimensions
