4-32
Confidential
6.2 Supply of Water
(1) Open the ink cartridge cover and turn ON the machine.
(2) Enter the maintenance mode, and press the 1 and 8 buttons in this order.
"PlatenPosition" is displayed on the LCD.
(3) Set the ink cartridge in the machine.
(4) Select "OptimizerSupply" using the button, and press the button.
(5) Select "SUPPLY OPTIMIZER" using the button, and press the OK button.
The machine starts supplying water.
(6) When the machine finishes supplying water, turn the power OFF and ON.
6.3 Supply of Ink to Drive Switching Unit and Check of Ink Leak
(1) Check that the ink cartridge is installed.
(2) Press the 1 and 7 buttons in this order in the initial state of the maintenance mode.
"Cartridge" is displayed on the LCD. If the machine displays "No Cartridge" on the LCD,
press the button to display "Cartridge" on the LCD.
(3) Press the Go button. "NORMAL_P ALL" is displayed on the LCD.
(4) Press the 3 button to display "POWER_P ALL" on the LCD.
(5) Press the Go button. The machine displays "EXECUTING" on the LCD and starts
supplying ink.
(6) Check that no ink is leaking from the junctions between the tubes while ink is being
supplied.
(7) When the machine finishes supplying ink, it displays "COMPLETED" on the LCD.
(8) Press the Go button to return to the initial state of the maintenance mode.
(9) Press the 9 button twice to return to the ready state.
6.4 Resetting of Drive Switching Unit Counter
(1) While the machine is in the ready state, press the Go and buttons at the same time.
"Reset Menu" is displayed on the LCD.
(2) Press the or button to select drive switching unit, and press the OK button.
"1.Reset 2.Exit" is displayed on the LCD.
(3) Press the 1 button. The machine displays "Accepted" on the LCD. The replacement
counter of the drive switching unit increases, and the machine returns to the ready state.
(4) Turn OFF the power of the machine.
6.5 Attachment of Side Cover L
(1) Attach the side cover L.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
