Brother HL-S7000DN - 10.31 Platen Unit

3-111
Confidential
10.31 Platen Unit
1) Insert the AC cord to the machine, enter the initial state of the maintenance mode,
and press the 1 and 8 buttons in this order. "PlatenPosition" is displayed on the LCD.
2) Press the or button to display "WipeGlassSurface" on the LCD, and press
the button. Check that "BLACK" is displayed on the LCD to replace the Ink head
wiper ASSY.
3) Press the OK button. The glass face goes down.
4) Press the button. "WipeGlassSurface" is displayed on the LCD.
5) Press the or button to display "BlackWipe" on the LCD, and press
the button.
6) Press the or button to display "NOZZLE WIPE POS" on the LCD, and press the
OK button.
7) Insert the AC cord to the machine, enter the initial state of the maintenance mode,
and press the 1 and 8 buttons in this order. "PlatenPosition" is displayed on the LCD.
8) Press the or button to display "WipeGlassSurface" on the LCD, and press
the button.
To replace the Pre-coat head wiper ASSY, press the or button to display
"PRECOAT" on the LCD.
9) Press the OK button. The glass face goes down.
10) Press the button. "WipeGlassSurface" is displayed on the LCD.
11) Press the or button to display "PrecoatWipe" on the LCD, and press
the button.
12) Press the or button to display "NOZZLE WIPE POS" on the LCD, and press the
OK button. Pull the Open lever, open the Top cover, and check that the Ink head
wiper ASSY and Pre-coat head wiper ASSY is moved to the replacement position.
13) Pull out the AC cord from the machine.
Note:
Perform the following procedures before the replacement job to move the Ink head wiper
ASSY and the Pre-coat head wiper ASSY to the replacement position.