SUMMARY STEPS
1.
Attach the front rack-mount brackets. Locate the threaded holes in the front sides of the chassis (first holes
beyond the vent holes) and use the package of black screws that shipped with the chassis.
2.
Align the front rack-mount bracket to one side of the chassis.
3.
Insert and tighten the screws on one side.
4.
Repeat Step 2 through Step 3 on the other side of the chassis. Use all the screws to secure the rack-mount
brackets to the chassis.
5.
Gather the two cable-management brackets and screws shipped with your chassis. The followng image
shows attached cable-management brackets on the front of the Cisco ASR 1004 Router.
6.
Screw the cable-management bracket to each side of the rack-mount brackets already attached to the
chassis. Use two screws for each cable-management bracket. Use the package of four screws.
7.
Check that all screws are securely tightened.
DETAILED STEPS
Step 1
Attach the front rack-mount brackets. Locate the threaded holes in the front sides of the chassis (first holes beyond the
vent holes) and use the package of black screws that shipped with the chassis.
Step 2
Align the front rack-mount bracket to one side of the chassis.
Step 3
Insert and tighten the screws on one side.
Step 4
Repeat Step 2 through Step 3 on the other side of the chassis. Use all the screws to secure the rack-mount brackets to
the chassis.
The cable-management brackets are installed on the chassis after you install the chassis rack-mount brackets
and mount the chassis in the rack.
Note
Step 5
Gather the two cable-management brackets and screws shipped with your chassis. The followng image shows attached
cable-management brackets on the front of the Cisco ASR 1004 Router.
Cisco ASR 1000 Series Router Hardware Installation Guide
189
Cisco ASR 1004 Router Overview and Installation
Equipment Shelf or Tabletop Installation
To Next Page
Loading...
Need help?
General
