Cisco ASR 1002-X Hardware Installation Guide

CHAPTER 11
Cisco ASR 1013 Router Overview and Installation
This chapter describes the Cisco ASR 1013 Router and provides the procedures for installing the Cisco ASR
1013 Router in equipment racks and hardware upgrade process.
This chapter contains the following sections:
•
Cisco ASR 1013 Router Description, page 365
•
Installation Methods, page 371
•
General Rack Installation Guidelines, page 372
•
Guidelines for Equipment Rack Installation, page 373
•
Attaching the Rear Rack-Mount Brackets, page 374
•
Rack-Mounting the Cisco ASR 1013 Router, page 376
•
Attaching the Cable-Management Bracket, page 386
•
Attaching a Chassis Ground Connection, page 388
•
Connecting the Shared Port Adapter Cables, page 391
•
Connecting the Console and Auxiliary Port Cables, page 391
•
Connecting Power to the Cisco ASR 1013 Router, page 393
•
Connecting a Terminal to the Cisco ASR 1000 Series RP Console Port, page 402
•
Connecting the System Cables, page 403
•
Attaching Cable Retention Bracket on AC Power Supply, page 404
Cisco ASR 1013 Router Description
The Cisco ASR 1013 Router supports full-width card modules. It is designed with a single midplane with
connectors on one interface midplane. The Cisco ASR 1013 Router supports:
•
Up to 6 ASR1000-SIP40G shared port adapter modules
•
Up to 24 shared port adapters (SPAs) and up to six SIPs
Cisco ASR 1000 Series Router Hardware Installation Guide
365

Cisco ASR 1002-X Specifications

General

Form Factor	Rack-mountable
Rack Units	2RU
Integrated Services	Yes
Maximum Memory	16 GB
Built-in Gigabit Ethernet Ports	6
Input Voltage	100-240 VAC
Operating Temperature	32 to 104°F (0 to 40°C)
Redundancy	Power supply redundancy
Network Interface Modules	Up to 4 SPA/SIP slots
Embedded Services Processor (ESP)	ESP-20
Maximum Packet per Second (PPS)	15 Mpps
Height	3.5 inches
Fixed Ports	6 GE ports
Memory	4 GB (default), 16 GB (maximum)
Power Supply	Dual power supplies (AC or DC)
Dimensions (H x W x D)	3.5 x 17.5 x 19.0 in (8.9 x 44.5 x 48.3 cm)