Cisco ASR 1002-X Hardware Installation Guide

CHAPTER 2
Cisco ASR 1000 Series Routers Component
Overview
This chapter contains the following sections:
For the Cisco Embedded Services Processor see, xref and for the SPA Interface Processor see, xrefNote
•
Cisco ASR 1000 Series Routers Component Software Support, page 25
•
Supported ASR 1000 Hardware Components, page 27
•
Cisco ASR 1000 Series Route Processor, page 36
•
Cisco ASR 1000 Series Router Power Supplies, page 48
•
Power Supplies for the Cisco ASR 1006 Router, page 51
•
Power Supplies for the Cisco ASR 1004 Router, page 59
•
Power Supplies for the Cisco ASR 1002 Router, page 66
•
Power Supplies for the Cisco ASR 1013 Router, page 76
•
Power Supplies for the Cisco ASR 1001 Router, page 83
Cisco ASR 1000 Series Routers Component Software Support
This section lists the new hardware supported on the Cisco ASR 1000 Series routers and the version of Cisco
IOS software code required to support the component. xref table lists the components that are not supported
by earlier releases of Cisco IOS XE.
Cisco ASR 1000 Series Router Hardware Installation Guide
25

Cisco ASR 1002-X Specifications

General

Form Factor	Rack-mountable
Rack Units	2RU
Integrated Services	Yes
Maximum Memory	16 GB
Built-in Gigabit Ethernet Ports	6
Input Voltage	100-240 VAC
Operating Temperature	32 to 104°F (0 to 40°C)
Redundancy	Power supply redundancy
Network Interface Modules	Up to 4 SPA/SIP slots
Embedded Services Processor (ESP)	ESP-20
Maximum Packet per Second (PPS)	15 Mpps
Height	3.5 inches
Fixed Ports	6 GE ports
Memory	4 GB (default), 16 GB (maximum)
Power Supply	Dual power supplies (AC or DC)
Dimensions (H x W x D)	3.5 x 17.5 x 19.0 in (8.9 x 44.5 x 48.3 cm)