Cisco ASR 1002-X Hardware Installation Guide

Corrective ActionCauseSymptom
The image file name specified in the boot
command is invalid.
An error message similar to the following
example is displayed when you try to boot
the system, and then the router switches to
the rommon prompt:
Directory an_image.bin not found
Unable to locate an_image.bin
directory
Unable to load an_image.bin
boot: error executing "boot
harddisk:an_image.bin"
autoboot: boot failed, restarting
Cisco ASR 1000 Series Router Hardware Installation Guide
653
Troubleshooting Initial Startup Problems
Troubleshooting the Upgrade

Cisco ASR 1002-X Specifications

General

Form Factor	Rack-mountable
Rack Units	2RU
Integrated Services	Yes
Maximum Memory	16 GB
Built-in Gigabit Ethernet Ports	6
Input Voltage	100-240 VAC
Operating Temperature	32 to 104°F (0 to 40°C)
Redundancy	Power supply redundancy
Network Interface Modules	Up to 4 SPA/SIP slots
Embedded Services Processor (ESP)	ESP-20
Maximum Packet per Second (PPS)	15 Mpps
Height	3.5 inches
Fixed Ports	6 GE ports
Memory	4 GB (default), 16 GB (maximum)
Power Supply	Dual power supplies (AC or DC)
Dimensions (H x W x D)	3.5 x 17.5 x 19.0 in (8.9 x 44.5 x 48.3 cm)