This will help configure the gateway through Cisco IOS CLI.
Step 8
As part of editing your gateway configuration, older configuration will be erased first. Copy and paste the
command erase startup-config to the gateway console.
Type Return to confirm erasing configuration at prompt:
Erasing the nvram filesystem will remove all configuration files! Continue?
[confirm]
Step 9
Copy and paste the command reload to startup the gateway fresh.
If prompted to save current system configuration, Type 'Yes' at prompt:
System configuration has been modified. Save? [yes/no]: yes
Type Return to proceed with reload at prompt:
Proceed with reload? [confirm]
Wait for a few minutes while the gateway reloads.
Step 10
When the gateway comes back up, enter the following answer when the system message appears on the
gateway.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 11
If prompted to terminate auto install, press Return and continue with manual configuration:
Would you like to terminate autoinstall? [yes] Return
Several messages are displayed, ending with a line similar to the
following:
...
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled
<date>
<time>
by
<person>
Step 12
Press Return to bring up the Router> prompt.
...
flashfs[4]: Initialization complete.
Router>
Step 13
Type enable to enter privileged EXEC mode:
Router> enable
Router#
Step 14
Copy and paste rest of the commands onto the gateway prompt, line by line, to complete your gateway setup.
Step 15
At the end of this configuration, Telnet access password is set to changeme. To change this, type the following
at the gateway prompt:
Router# configure terminal
Router(config)# line vty 0 4
Router(config-line)# password <Your new Telnet password>
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
136 OL-27022-01
Editing the Gateway Configuration
To Next Page
Loading...
