Cisco IE-3000-8TC Administration Guide

CHAPTER 53
Reimaging or Replacing the Cisco Business
Edition 3000 Server
This chapter contains procedures that you can perform to reimage the Cisco Business Edition 3000 server,
perform a server recovery, or replace the Cisco Business Edition 3000 server.
Perform these procedures only if your technical support team advises that you do so.Note
• Reimaging an MCS 7890-C1, page 453
• Using a Network Cable to Set Up Server Access to the Network, page 456
• Using the Cisco Network Configuration USB Flash Drive, page 457
• Performing Upgrade Using an USB Flash Drive, page 458
• Performing COP file Installation Using an USB Flash Drive, page 460
• Performing a Server Recovery, page 461
• Replacing the Cisco Business Edition 3000 Server, page 461
Reimaging an MCS 7890-C1
The MCS 7890-C1 comes preinstalled with Cisco Business Edition 3000. Cisco Business Edition 3000 software
supports a reimage through a USB DVD drive only.
Reimage the server only when your technical support team advises that you do so.Warning
USB hard disk drives and USB flash drives should not be plugged in during MCS 7890-C1 reimaging or
installation.
Note
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
OL-27022-01 453

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes