CHAPTER 20
Connection Groups
The Connection Groups page (Connections > Connection Groups) allows you to configure and manage
connection groups to route PSTN calls on the Cisco Business Edition 3000.
Table 37: Settings on the Connection Groups Page, on page 205 describes the settings on the Connection
Groups page (Connections > Connection Groups). Click Connection Groups to view the configured
connection groups for use with the Cisco Business Edition 3000.
Table 37: Settings on the Connection Groups Page
DescriptionSettings
Specifies the unique name of the connection group.
This name cannot exceed 47 characters and can contain only
alphanumeric characters, periods (.), underscores (_), hyphens
(-), or space ( ).
By default, there are 2 system-generated connection groups:
• All Connections—A system-generated connection
group, which includes all the gateways in the system,
listed in the order of SIP connections, MGCP
connections, PRI connections, CAS connections and
SPA analog gateways.
• <<Sitename>> Connections—A system-generated
connection group formed after migration to Release
8.6.4, which includes all the gateways on that site before
migration.
By default, each site uses its respective connection
group. When a new site is created, the All Connections
connection group is created by the system and will be
used as a default connection group.
Name
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
OL-27022-01 205
To Next Page
Loading...
