Cisco IE-3000-8TC Administration Guide

DescriptionParameter
Enter the appropriate IP Address based on the customers LAN.
This is a mandatory requirement to change the network configuration.
IP Address
Enter the appropriate subnet mask of the customers LAN.
This is a mandatory requirement to change the network configuration.
SubnetMask
Enter the gateway details of the customers LAN. This is an optional
requirement.
Gateway
Step 3
Save the Network Configuration signature file to the Cisco Network Configuration USB Flash Drive.
Step 4
Remove the Cisco Network Configuration USB Flash Drive from the laptop and put it in a location that you
will remember.
Step 5
If you have not already done so, install the Cisco Business Edition 3000 server in the customer LAN and
power it up.
Step 6
Insert the Cisco Network Configuration USB Flash Drive in Cisco Business Edition 3000.
This triggers the USB Diag Script and creates a temporary network interface, which contains the Network
Configuration signature file details.
Step 7
Connect the laptop to Cisco Business Edition 3000 and open a browser to access the Cisco Business Edition
3000 First Time Setup Wizard by using the IP Address that is configured in the Network Configuration
signature file.
Step 8
After you sign in, you may update the network parameters, including the IP address of the server:
• On the Network page in the Cisco Business Edition 3000 First Time Setup Wizard (during the initial
deployment)
• By uploading the Cisco-provided .xls data configuration file in the Cisco Business Edition 3000 First
Time Setup Wizard (during the initial deployment)
After you access the Cisco Business Edition 3000 Administrative Interface, you can also generate the
configure.xml file from the Network page and save it to a USB Flash Drive. Select System Settings
> Network.
Tip
USB Support, on page 5
Troubleshooting with the Network USB Flash Drive When You Cannot Access the Administrative
Interface, on page 422
Questions to Ask Your Customer
As the Value Added Reseller (VAR), ask the customer the questions from the following table to ensure that
you have the information that you need to deploy the sites. These questions serve as examples, and you may
find that you need to ask additional questions as you communicate with your customer.
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
OL-27022-01 129
Questions to Ask Your Customer

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes