Cisco IE-3000-8TC Administration Guide

CHAPTER 54
Cisco Business Edition 3000 TCP and UDP Port
Usage
This chapter provides a list of the TCP and UDP ports that Cisco Business Edition 3000 Release 8.6(2) uses
for communications with external applications or devices.
Cisco has not verified all possible configuration scenarios for these ports. If you are having configuration
problems using this list, contact Cisco technical support for assistance.
Note
The ports that are listed in this chapter apply specifically to Cisco Business Edition 3000 Release 8.6(2).
Some ports change from one release to another, and future releases may introduce new ports. Therefore,
make sure that you are using the correct version of this document for the version of Cisco Business Edition
3000 that is installed.
The Ephemeral port range for the system is 32768 to 61000.Note
• Port Descriptions, page 463
• Glossary, page 465
• References, page 466
Port Descriptions
The following table describes the ports that are used by Cisco Business Edition 3000.
Table 108: TCP and UDP ports used by Cisco Business Edition 3000
PurposeDestination portTo (Listener)From (Sender)
Secure FTP service, SSH
access
22 / TCPEndpointCisco Business
Edition 3000
Administration Guide for Cisco Business Edition 3000, Release 8.6(4)
OL-27022-01 463

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes